
Traction/Auger
Control Lock--------_
Shift Lever
Auger Control
Discharge Chute
Chute
Clean-out Tool
Auger
Chute Directional Control
Choke
._Spark Plug
Recoil Starter
Handle
Ignition Key
Throttle Control
Cl°sed7 /r_ \_ I
Fuel Shut-Off Valve I
Figure 14
ChuteClean-0ut T001
WARNING: Never use your hand to clear a
clogged discharge chute. Shut off engine and
remain behind handles until all moving parts
have stopped before unclogging.
The chute clean-out tool (see Figure 14)is designed to
clear a clogged discharge chute. Refer to OperatingYour
SnowThroweron page 13 for detailed instructions on how
to properly use the chute clean-out tool.
Ignition Key
The ignition key must be inserted in the switch in order
for the engine to start. Remove the ignition key when
the snow thrower is not in use.
NOTE: Do NOT 'turn" the ignition key in an attempt to
start the engine. Doing so may cause it to break.
Fuel Shut-0ffValve (optional equipment)
On models so equipped, the fuel shut-off valve, located
under fuel tank, controls fuel-flow from the gas tank.
See Figure 14.
Throttle Control
The throttle control is located on the engine. It regulates
the speed of the engine. See Figure 14.
SECTION5: OPERATINGYOURSNOWTHROWER
BeforeStarting
_ WARNING" Read, understand, and follow
all instructions and warnings on the machine
and in this manual before operating.
• The spark plug wire was disconnected for safety.
Attach spark plug wire to spark plug before starting.
GasAndOilFill-up
• At the factory, a plastic cup is inserted inside the
fuel tank's fill opening (beneath the fuel cap) to
prevent debris from entering the fuel tank during
assembly. Remove and discard this cup before
filling up the tank.
WARNING: Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoor or while the
engine is hot or running. Extinguish
cigarettes, cigars, pipes and other sources of
ignition.
StartingEngine
IMPORTANT:Prior to operating your snow
thrower, read, understand and follow ALL
instructions to perform adjustments found
under the heading AugerControlTest on
page 13 of this manual.
11
Comentarios a estos manuales